Polls

Within the context of its era, which version of AutoCAD was the most STABLE?
 

Subscribe
Multiple Offset (mof)
MOF is used to offset a single entity multiple distances.
Read more...
 
Freeze in all Non Active ViewPorts (fnavp)

Freeze in all Non Active ViewPorts will VPFREEZE a picked entity's layer in all viewports except for the currently active viewport.
Read more...
 
Lock All Viewports (lav)
LAV (Lock All Viewports) is used to lock all of the viewports in your current drawing with a single command.
Read more...
 
Change DVIEW to Horizontal (dvh)

DVH (dview - horizontal) is a simplified version of the dview / twist command. Simply pick two points in your current view and your view will be twisted to make those two points horizontal. The snap angle is also set to the current view.
Read more...
 
Insert Cut Section (cutsec)

Draws section-cut indicators at points specified by user. Insertion angle is angle between two picked points.
Read more...
 
<< Start < Prev 1 2 3 Next > End >>

Results 1 - 5 of 13

THIS INFORMATION IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.

Copyright © 2008, http://www.texupport.net/