Polls

Within the context of its era, which version of AutoCAD was the most STABLE?
 

Subscribe
Spline option in PEDIT command doesn't work after join has been executed PDF Print E-mail
Wednesday, 05 March 2008

After joining lines or polylines within the PEDIT command, the SPLINE option can't be run until the command is ended and reexecuted.

Steps to reproduce:

  • Draw three lines which meet end to end
  • Enter PEDIT (if peditaccept is turned off, hit "y")
  • Select J to join the segments
  • Select S to spline the resulting polyline
  • Notice that the command is exited

Workarounds: Exit the PEDIT command after joining the segments, then reexecute PEDIT and select S to spline.

First Appeared: 2007? (This bug is definitely not evident in 2004 and is known to exist in 2007.  Its status in 2005 and 2006 is unknown)
Status as of 2008 SP1: Still reproducible.

Thanks to Opie for submitting this report.
 
< Prev   Next >

THIS INFORMATION IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.

Copyright © 2008, http://www.texupport.net/