texupport

Spline option in PEDIT command doesn’t work after join has been executed

After joining lines or polylines within the PEDIT command, the SPLINE option can’t be run until the command is ended and reexecuted.

Steps to reproduce:

• Draw three lines which meet end to end
• Enter PEDIT (if peditaccept is turned off, hit “y”)
• Select J to join the segments
• Select S to spline the resulting polyline
• Notice that the command is exited

Workarounds: Exit the PEDIT command after joining the segments, then reexecute PEDIT and select S to spline.

First Appeared: 2007? (This bug is definitely not evident in 2004 and is known to exist in 2007.  Its status in 2005 and 2006 is unknown)
Status as of 2008 SP1: Still reproducible.

Thanks to Opie for submitting this report.